Not every panel job is about replacing an old one. Sometimes you need a brand new panel where there wasn't one before. A new build. A finished garage or shop that needs its own power. A big addition. Or a subpanel to feed a workshop, a pool, or a detached building. That's a different kind of job, and it's one we do a lot.
When Homeowners Need Electrical Panel Installation Near Me
You might be looking up electrical panel installation near me because you're building or adding on, wiring a new garage or shop, running power to a detached building, or setting up a subpanel so one area has its own breakers close by. Subpanels are handy when the main panel is far away or already full, and you want dedicated circuits for a specific space. Whatever the reason, a fresh panel install has to be planned and sized right from the start.
Getting the Size and Setup Right
A new panel is a chance to do things properly. We calculate the load for what you're powering, pick the right panel size, and plan the circuits so you're not maxed out on day one. Good grounding and bonding, correct wire gauge, clean labeling, all of it matters for a panel that's safe and easy to work with for years. This is where a rushed job causes headaches later, so we take the time to plan it. Choosing electrical panel installation near me with a licensed crew means it's done to the National Electrical Code from the first wire.
Subpanels Made Simple
A subpanel branches off your main panel to serve a specific area with its own set of breakers. It's a clean way to add power to a garage, shop, pool equipment, or a home addition without cramming everything into the main box. We size the feeder correctly, install a properly rated subpanel, and make sure it plays nice with your existing service.
Permits, Inspection, and Utility Coordination
New panel work needs a permit and inspection through MABCD, and sometimes coordination with Evergy. We handle the paperwork and scheduling so it passes clean. Book electrical panel installation near me, and we manage the whole thing start to finish.
How Long Does a Panel Installation Take?
Plan on a single day for most of them. A straightforward panel install, or a subpanel added for a garage or workshop, is typically morning-to-evening work, power goes off while we make the swap, and comes back on once everything is landed, torqued, and labeled. If the meter base or service entrance needs work too, or the panel is moving to a new spot, it can stretch further, and we'll tell you that up front rather than let the day surprise you.
The inspection through MABCD happens after the work, and with Evergy in the loop for reconnection, the choreography matters, book the utility late and a one-day job becomes two. We've run that sequence enough times to keep it tight, which is most of what you're hiring when you hire a panel crew that does this weekly.